Installation guide

Square post

Pole installation. Brighten up your driveway, backyard or parking lot!

See the product

Adapter

Installation on all flat surfaces. Light up your patio, your stone wall or your balcony!

See the product

Recommendations

Our product illuminates using solar energy. Be sure to position the floor lamp in a location exposed to direct daylight for a minimum of 5 hours per day for optimal operation.

On pole

Step 1

Install the base of the pole on the sono tube

2nd step

Install the fixture on the pole

Explanations - On pole

Step 1: Fixing the post to the ground

Recommended method : installation on sonotube.

How : This technique must be carried out by a professional.

Recommended Screws: 410 Stainless Steel Hex Head Tapered Screw Anchor (Drill Included), 1/4" x 2-1/4"

Why on sonotube: This method is the only durable and safe installation solution that ensures a stable post through the change in soils that freeze in winter and thaw in spring. Any other methods that do not reach below the ground freezing limit (4 feet deep) will result in an unstable installation that will lean or move in the ground.

Other possible methods: You can fix the floor lamp in any way you wish. 8 strategically positioned holes are present on the base of the post to allow the insertion of screws through different surfaces and materials, depending on the method chosen.

Step 2: Assemble the light on the post

Parts included: 4 screws

- Install the post to the ground according to the method chosen in step 1.

- Place the light on the plate located above the post.

- Screw the 4 screws through the holes, as shown in the photo ''Step 2''.

- Choose the desired lighting mode then recharge the lamp for at least 5 hours in a location receiving sunlight.

**Be careful to hold the lamp securely in place to avoid dropping it when installing the screws.

On adapter

Step 1

Fix the adapter to the flat surface of your choice.

Step 2

Assemble the light onto the adapter

Étape 1: Vis non incluses : Le type de vis choisis dépend de la surface d'installation. Voir les explications ci-bas pour plus de détails !

Étape 2: Visser les 4 vis incluses avec la clé allen fournie pour installer le lampadaire sur l'adaptateur.

Quel Mode ?

LOW = 300 lumens

HIGH = 400 lumens

AUTO: Ce mode est seulement utilisé pour le transport sécure des lampadaires pendant la livraison.

OFF = La batterie va recharger avec le soleil mais ne vais PAS illuminer le soir.

Explanations - On adapter

Step 1: Fixing the adapter on a surface

Recommended location: A flat surface of your choice. Make sure it can support the weight and width of the lamp. For example, the railing of your wooden patio, your stone wall, etc.

How to: You can attach the adapter to the desired location by the help of the 4 holes at the base of the adapter which allow the insertion of screws. The type of screw used will vary depending on the type of surface chosen.

*For a wood surface, we recommend the following type of screw: Grade 18-8 stainless steel hex head lag screw, 1/4 in.-10 x 1 in.

Step 2: Assemble the light onto the adapter

Parts included: 4 screws

- Install the adapter according to the method chosen in step 1

- Place the light on the plate located above the adapter. The top plate is the widest. Refer to the images above.

- Screw the 4 screws through the holes, as shown in the photo in step 2.

- Choose the desired lighting mode then recharge the luminaire for at least 5 hours in a location favorable to sunlight.

**Be careful to hold the lamp securely in place to avoid dropping it when installing the screws.

Questions?

Contact us or refer to our FAQ section